ACIST CVi - Setup Procedures for the CVi System; Setup Overview and Initial Steps

Setup Overview
32 | English (USA) 2019-08 901418-003,01 ACIST | CVi® System User's Guide
4 Setup
e setup procedure involves the following general steps:
1. Supplying power to the system.
2. Installing patient kits.
3. Removing air from all system components and from the entire patient
catheter. Air is removed from the system manually with a hand syringe
and automatically using purge and ush functions via the control panel
touchscreen and the hand controller.
Aer the system power is switched on, the control panel on the CVi system will
provide guidance during the setup procedure by displaying onscreen prompts.
Aseptic technique must be followed when performing setup. Take particular
care to protect connectors from incidental contact. See Aseptic Technique on
page 6 for more information.
Note
Alternate setup workows may be used depending on the specic
requirements of your healthcare institution.
1. Turn the power switch on. e power switch is located on the power
supply.
Setup Overview
Power On
Power switch