ACIST CVi - Page 4

4 | English (USA) 2019-08 901418-003,01 ACIST | CVi® System User's Guide
6 End a Case
End the Case ..................................47
End Case...................................47
If Beginning a New Case with
the Same Syringe .......................47
If Using a New Syringe .....................48
If Final Case................................49
Emergency Case ...........................49
7 Supplementary Procedures
General Cleaning Instructions .................51
Cleaning / Disinfection Procedure ..........52
Monthly Inspection ...........................54
Annual Preventive Maintenance ...............54
Storage of Cart-Mounted Systems .............54
Transfer the Injector Head
to/from a Pedestal Cart ........................55
Cabling .......................................56
Connect the Injector Head Cable ...........56
Connect the Control Panel Cable ...........56
Connect the X-Ray Interface Cable on
Standard Systems (Optional) ............57
Connect the X-Ray Interface Cable on
Siemens-Ready Systems (Optional) ......58
Plug In the Power Supply...................59
Mount the Power Supply on a Cart (Optional) ..60
Recalibrate Control Panel Screen...............61
Change the Display Language and
Pressure Units.................................61
Display Language..........................61
Calculate Parameters from Patient Weight......62
Resume an Interrupted Case...................62
Pressure Units..............................62
Change Color Scheme.........................63
System Info ...................................63
Keep Vessel Open (KVO) Injection (Optional) ...63
KVO Injection ..............................63
KVO Rate ..................................63
8 Troubleshooting
Frequently Asked Questions ...................65
Troubleshooting the CVi System ...............67
Air Column Detected.......................67
Contrast Empty/No Contrast ...............67
Hand Controller Calibration Failed ..........68
Pressure Limit Exceeded....................68
Standby!...................................68
Manifold Valve Open .......................68
Manifold valve failed to close n times
using current syringe.
Use new syringe? .......................69
Manifold Valve Open Conditions Requiring
Syringe Replacement ...................69
Syringe Valve Closed .......................69
Syringe Valve Open ........................70
Injection Does Not Start....................70
Power Failure ..............................70
Troubleshooting Hemodynamic Issues.........71
Zero Fluctuations ..........................71
Cannot Obtain Zero or Lose Zero Before
Procedure ..............................72
Waveform Dampened......................72
System Messages .............................73
9 Specications
Load Rate .....................................81
Saline Rate ....................................81
Contrast
Injection Parameters ..........................81
Cardiac procedure mode ...................81
Peripheral procedure mode ................81
Pedestal Cart Dimensions .....................82
Accuracy ..................................82
Weight........................................83
Environmental Limits..........................83
Transportation .............................83
Power Supply .................................84
Patient Kits....................................84
Standard ..................................84
Power cord ................................84
Electrical Leakage..........................84
Hemodynamic Transducer.....................85
Supported Imaging Systems...................85
UL Approval ..................................86
10 EMC Tables
EMC Requirements ............................87
11 Limited Warranty