2
I. GENERAL INFORMATION 3
II. TECHNICAL PARAMETERS 4
III. OPERATION 5
IV. DESCRIPTION OF ADDITIONAL AND SPECIAL MODULES 9
V. RECEIVERS - INFORMATION AND ASSEMBLY 13
VI. INSTALLATION 14
VII. CALLING 16
WIRING DIAGRAM - INSTALLATION WITH ONE DOOR ENTRY UNIT 21
VIII. SYSTEMS WITH LARGER NUMBER OF DOOR ENTRY UNITS 23
CONNECTION OF SLAVE PANELS 24
WIRING DIAGRAMS FOR INSTALLATIONS WITH MULTIPLE DOOR ENTRY UNITS 26
SUPPORTING UP TO 1020 APARTMENTS 29
IX. DOORMAN 31
X. OPERATION 32
XI. VOLUME LEVEL ADJUSTMENT 32
XII. PROGRAMMING 33
P0 SERVICE ACTIVATION OF E-LOCK 34
P1 MODIFICATION OF USER’S ACCESS CODE 34
P2 CHANGING THE ADMINISTRATOR'S ACCESS CODE AND ADDING PROXIMITY CARDS / KEY FOBS FOR
ADMINISTRATORS 35
P3 SETTING THE NUMBER OF RINGTONES, PERMISSION TO CALL 36
P4 TURNING ON - OFF THE DOOR OPENING SIGNAL IN THE APARTMENT 36
P5 SETTING ONE OF FOUR RINGTONES 37
P6 SETTING THE E-LOCK TIME 37
P7 CHANGING THE INSTALLER’S PASSWORD AND ADDING INSTALLER’S PROXIMITY CARDS / KEY FOBS 38
P8 VERIFYING CARD ASSIGNMENT TO APARTMENTS 39
P9 ENTERING NEW ACCESS CODE TABLE 39
P10 E-LOCK 39
P11 DISABLING FACTORY SETTINGS RESET 40
P12 ADDING RESIDENTS’ PROXIMITY CARDS / KEY FOBS 40
P13 PROGRAMMING THE MODULE USING xNP DIRECT CALL BUTTONS (x - number of buttons) 41
P14 OPENING DELAY FROM INPUT 41
P15 TIME TO MESSAGE: "CALL SERVICE” 41
P16 INSTALLER'S CALL FROM APARTMENT 42
P17 SERVICE CALL FROM APARTMENT 43
P18 SEARCHING MISPLACED OR DEFECTIVE UNIPHONES 43
P19 LINE TESTING 44
XIII. CHANGE OF MESSAGE LANGUAGE 45
XIV. RESTORING FACTORY SETTINGS AND DELETING MODULE MEMORY 45
XV. FACTORY SETTINGS 46
XVII. CLEANLINESS 47
XVIII. SAFETY RULES FOR INSTALLATION AND USE 47
XIX. RULES FOR STORING WASTE ELECTRICAL EQUIPMENT 47
XX. TROUBLESHOOTING 48
XXI. LIST OF CHANGES IN SOFTWARE VERSIONS 49
It is forbidden to install the units without first reading the
following instructions.
To Next Page
Loading...
