34
be entered; the new setting must be confirmed with the "Key" button or can be
cancelled with the "#" button (if no new value is entered, the unit will automatically
exit this menu item, without changing any value of the setting).
Exit the installer's menu by pressing the "#" button or leave the unit idle for a
longer while for it to exit the menu automatically. Upon exiting the installer’s menu,
the unit will display its current inner temperature.
Relevant functions (or programs) available in the installer’s menu are described
below
P0 SERVICE ACTIVATION OF E-LOCK
Maintenance function - verification of E-lock operation and proper opening time.
When the function is called (by pressing the "key" button), the opening procedure
starts: release for a pre-set time of the E-lock connected to the ELOCK output
and exiting the installer’s menu. Calling the function also disables the installer's
uniphone calling function from apartment and the service uniphone calling
function from apartment.
P1 MODIFICATION OF USER’S ACCESS CODE
Modification of the 4-digit resident’s access code.
Upon entering this function, the display will show “Lokal?”; enter the apartment
number, confirm with the "key" button (the 6-digit apartment is confirmed
automatically upon entering the last digit). The current code will be displayed for
a short while (press # now to leave the function without changing the code), and
then "----" will be displayed; now the four digits of the new code can be entered.
The unit will display " Ready"; the new code is now stored in unit’s memory.
Now the value “Local?” is the new call number, to be selected with the keypad
(the physical address of the receiver is calculated by the unit). Please note that
the access codes in the Code Table correspond to the physical addresses set in
the receivers.
When factory settings are restored, so are the codes, to the pre-set code table.
To lock the access codes completely, set the "9999” code table.
Code modification example
Changing the conde of apartment 9 to 4256: Enter the program, wait for
"Local?” to be displayed, then enter 9, confirm with "key". The current code will
be displayed for a short while, followed by “----”; now enter 4256. "Ready" will
be displayed and code 4256 for apartment 9 will be stored in unit’s memory.
To Next Page
