47
Multimaster module (CDN-MM) not supported
4-zone switch (SW4S-DIN) not supported
XVII. CLEANLINESS
Cleaned the door entry unit with a damp or antistatic cloth.
Do not use any solvents!
XVIII. SAFETY RULES FOR INSTALLATION AND USE
Installation should be carried out by a qualified installer.
Turn off the power supply before opening the panel housing.
Avoid unstable power sources and electrical surges as this may cause
malfunction or damage to the panel.
When using a metal frame, it is mandatory to ground the housing (using
the marked terminal on the base) with a suitable protective installation (PE).
When trained to operate the panel, the user should be briefed that any
errors in its operation may only be corrected by a qualified and authorised
person.
Do not expose the panel to any kind of corrosive chemicals, as this may
damage the unit.
The applicable OHS regulations must be observed when working on the
door entry system.
XIX. RULES FOR STORING WASTE ELECTRICAL EQUIPMENT
Waste electrical equipment must not be disposed of with other waste. It should
be stored in places designated for this purpose. For this purpose, please contact
the responsible institutions or companies involved in waste recycling. - Directive
2002/96/EC of 27.01.2003
To Next Page
Loading...
