Accessories and options 137
fabian HFO | SW 5.1.x
Ref: 113003.EN / Date 2020-02-10
It activates the next step and can be used to skip the remaining
time of the stabilization period.
It starts the whole FOT procedure and can be used to terminate it
anytime.
It can be used to repeat the reactance measurement.
It can be used to skip the upcoming higher-pressure level
measurements and continue at the previous step.
Feedback information fields – automatically calculated values
maximum 100 mbar in HFOV and 80 mbar in Conventional mode
* If FOTsteps is set to 1 then high-pressure setting is hidden and Pmean low and PEEPlow text is
changed to Pmean and PEEP respectively.
** The difference between the high and low-pressure parameters can be minimum 1 mbar) or more if
the setting of the number of FOT measurements (FOTsteps) is bigger than 3 because of the step
size cannot be lower than 1 mbar.
To Next Page
Loading...
Need help?
General
