6146/6156 DC Voltage/Current Generators Operation Manual
2.2.1 Setting Source Value
2-14
• If the set value is below the lowest digit, it is rounded off.
• If the final value would exceed the valid range, change is not possible.
An error is generated and changes do not occur.
CAUTION: Do not apply voltage from the outside in the 30 mV and 300 mV ranges that employ resistive
dividing output.
The internal circuits may be damaged because the limiters do not function in these ranges.
(3 V range)
(30 V range)
Cursor (blinking)
Cursor (blinking)
UP
(30 V range)
(30 V range)
DOWN
To Next Page
Loading...