ADCMT 6156 User Manual

6146/6156 DC Voltage/Current Generators Operation Manual
2.3.2 Sweep Source Mode
2-50
4. Press the TRIG HOLD once to start the sweep. The source value changes to the
start value.
"SWEEP" blinks while the sweep is executed.
Every time the source value changes, blinks once.
In this way, every time TRIG HOLD is pressed, sweep step occurs.
5. The following figure shows the status when the sweep stop value is reached.
6. Pressing TRIG HOLD once changes the source value to the bias value when the
Return to bias is set to ON (RTB ON).
When the Return to bias is set to OFF (RTB OFF), the source value becomes the
start value.
7. When the Return to bias is set to ON (RTB ON), pressing STOP (PRGM
MODE) while the sweep is executed returns to the status before the start (bias
value). When the Return to bias is set to OFF (RTB OFF), pressing STOP
(PRGM MODE) while the sweep is executed stops the sweep as it is.
Blinking
Blinking

ADCMT 6156 Specifications

General

Brand	ADCMT
Model	6156
Category	Portable Generator
Language	English