6243/44 DC Voltage Current Source/Monitor Operation Manual
3.4 List of Settings
3-20
3.4 List of Settings
This list shows the setting ranges of the 6243/44 parameters and the factory settings.
To return to the factory settings, turn ON the power by pressing the + key.
When returning to the factory settings, all the parameters are initialized except for the line frequency, and the
data in the random memory is cleared.
Perameters stored in the non-volatile memory are also initialized and cleared. (Refer to Figure 2-13.)
3.4.1 6243 Setting Ranges and Factory Settings
Panel key Parameter group Parameter type Range Factory setting
SOURCE
Source mode
Source function
Source range
Source value
Limit
DC/PLS/SWP/PSW
VS/IS
320 mV to 110 V/32 A to 2 A
0.00 mV to 110 V/0.000 A to 2 A
3 mV to 110 V/300 nA to 2 A
DC
VS
320 mV
+000.00 mV
0500.0 mA
MEASURE
Measurement function
Measurement auto range
Null calculation
DC & pulse trigger mode
VM/IM
Auto / Fixed range
ON/OFF
RUN/HOLD
IM
Fixed (2A range)
OFF
RUN
MENU
SWEEP
Sweep type
Bias value
Start value
Stop value
Step value
Number of Logs and steps
Start address
Stop address
Sweep ranging
Number of repeat sweeps
Reverse mode
Sweep trigger mode
Linear/Log/Random
0.00 mV to 110 V/0.000 A to 2 A
0.00 mV to 110 V/0.000 A to 2 A
0.00 mV to 110 V/0.000 A to 2 A
0.01 mV to 110 V/0.001 A to 2 A
1/2/5/10/25/50 (Step/Decade)
0 to 4999
0 to 4999
Auto/Fixed
0 to 1000
ON/OFF
Internal/External
Linear
+000.00 mV
+000.01 mV
+001.00 mV
000.01 mV
10 Step/Decade
0
0
Auto Range
1
OFF
Internal
TIME
Measure delay time
Source delay time
Hold time
Period
Pulse width
Auto-range display time
0.30 ms to 60000 ms
0.01 ms to 60000 ms
3 ms to 60000 ms
2.00 ms to 60000 ms
1.00 ms to 60000 ms
0 ms to 500 ms
4.00 ms
0.01 ms
00010 ms
50.00 ms
25.00 ms
00000 ms
SOURCE
Pulse base value
Limiter polarity mode
Remote sensing
Limiter / OSC Buzzer
0.
00 mV to 110 V/0.000 A to 2 A
Auto/Plus/Minus
2 Wire/4 Wire
ON/OFF
000.00 mV
Auto
2 Wire
OFF
To Next Page
Loading...
Need help?
General
