159
ADOBE ILLUSTRATOR CS2
User Guide
See also
“About paths” on page 144
“Selection tool gallery” on page 262
“Keys for selecting” on page 528
To select all anchor points and segments in a path
1 Select the Direct Selection tool or the Lasso tool .
2 Drag a marquee around the entire path.
If the path is closed and filled, you can also click inside the path with the Direct Selection tool.
See also
“About paths” on page 144
“Selection tool gallery” on page 262
“Selecting filled objects” on page 264
“Keys for selecting” on page 528
To change the length or angle of straight line segments
1 Select the anchor point on either end of the line segment.
2 With the Direct Selection tool , drag the anchor point to the desired position.
If you’re simply trying to make a rectangle wider or narrower, it’s easier to select it with the Selection tool and resize
it using one of the handles on the sides of its bounding box.
See also
“To select anchor points” on page 158
To reshape curves
1 Select the anchor point on either end of the curved segment you want to adjust.
Direction lines appear on the selected anchor point, as well as on adjacent anchor points.
2 With the Direct Selection tool , drag the anchor point or a direction point.
See also
“To select anchor points” on page 158
“Direction lines and direction points” on page 157
To move anchor points using the keyboard
1 Select the anchor point.
2 Clickorholddownany of thearrow keys on thekeyboardtomoveapixelatatime in thedirection of thearrow.
Hold down the Shift key in addition to the arrow key to move the anchor point 10 pixels at a time.
To Next Page
Loading...