ADPRO iFT Series - 7.3 Configuring the MIO Card

iFT Series Hardware Installation Manual ADPRO
36 27817_08
7.2.4 Cable Strain Relief
Afterconnectingallthewires,useatie-wraptoattachthecablestotheXOdevice’schassis.Runthetie-wrap
throughtheslotsinthechassisasshownbelow.Thetie-wrapservesasastrainreliefandmakessurethatthe
wiringstaysinplacewhenhandlingtheXOdevice.
7.3 Configuring the MIO Card
Toconfiguretheinputsandoutputs,ortoupdatetheMIOcardfirmware,seetheXO Client Software User Manual
(21796).