ADPRO iFT Series - 21.2 Declaration of Conformity

To Next Page

To Previous Page

iFT Series Hardware Installation Manual ADPRO

76 27817_08

Note

HoneywellprovidesabroadrangeofiFTSeriesconfigurations,suitableforawidevarietyofsecurity

systemrequirements.

Foranoverviewoftheavailableconfigurations,andforadviceonselectingtheonethatbestsuits

yourneeds,pleasecontactyourHoneywellSalesRepresentative.

21.2 Declaration of Conformity

Main Page

Default Chapter5
- Table of Contents5
1 Technical Specifications7
2 About the Ift Series9
- Models9
- Licenses9
  - Overview9
  - System License10
- Software10
- Parts Information10
3 Hard Disks11
- Required Hard Disk Capacity11
- Adding/Replacing a Hard Disk11
- Reusing Used Hard Disks12
- Retrieving Hard Disk Information12
  - Using the Ta,Smart Command12
  - Using the XO Client Software13
- Installing the First Hard Disk13
- Installing a Second Hard Disk16
- Installing a Third Disk in an Ift Device19
- Installing a Third and Fourth Disk in an Ift-E Device22
- RAID 1 Support26
- Remote Formatting of Hard Disks27
4 Front LED Indicators29
5 Motherboards30
- Overview30
- BIOS Settings30
- Connectors30
- Replacing the Motherboard31
- Replacing the Motherboard Battery31
6 Connecting IP Cameras32
7 Main I/O Card34
- Features34
- Connection of Inputs and Outputs34
- Configuring the MIO Card36
8 XO I/O Interface USB Modules37
- About the XO I/O Interface USB Modules37
- Logging on to the Hardware Configuration Tool38
- Mapping the XO I/O Interface USB Modules40
- Resetting the Hardware Mapping42
9 Network I/O Units (Net I/O)43
10 Monitor44
11 Modem45
12 Via Wingle46
13 Audio47
- Audio in47
- Audio out (Talkback)47
- Using IP Audio Devices52
14 Connecting PIR Detectors53
- Required PIR Firmware53
- PIR Address Range53
- Direct Connection to the MIO Card53
- Connection Via the USB-To-RS-485 8-Channel Distribution Unit55
- Connection Via the USB-To-Serial-Port RS-485 Converter57
- Connection Via the IFM-485-ST Interface Module57
- Connection Via IP Modules (PRO E-IPM)58
15 Power Consumption64
16 Retrieving the IP Address65
17 Diagnostics66
- Log Files and Reports66
- Retrieving Log Files66
- Retrieving Reports68
18 Web70
19 Maintenance71
20 Full Reset by Flashing the DOM72
- Flashing the Image File to the DOM72
- After a Full Reset74
21 Product Labelling75
- Product Number Structure75
- Declaration of Conformity76
Appendix A - Abbreviations77

ADPRO iFT Series - 21.2 Declaration of Conformity

Table of Contents

Related product manuals