ADPRO iFT Series - Connecting IP Cameras; IP Network Connections

iFT Series Hardware Installation Manual ADPRO
32 27817_08
6 Connecting IP Cameras
AnXOdevicethatusesIPcamerasrequiresseparateIPnetworkconnectionsfor:
l ThenetworkforcommunicatingwiththeclientPC,CMS,NetI/Ounits,S3100panels…TheprimaryEthernet
connector(eth0)onthemotherboardprovidesthephysicalinterfaceforthisnetwork.
l ThenetworkfortheIPcameras.ThesecondaryEthernetconnector(eth1)onthemotherboardprovidesthe
physicalinterfaceforthisnetwork.
Note
ItisnotpossibletohaveoverlappingIPaddressrangesineth0andeth1;thesemustbeseparate.
WithsoftwareversionXO4andabove,thesystemwillcheckandissueawarningiftheIPaddresses
ofeth0andeth1areinthesamerange.