ADPRO iFT Series - Page 6

iFT Series Hardware Installation Manual ADPRO
6 27817_08
9 Network I/O Units (Net I/O) 43
10 Monitor 44
11 Modem 45
12 4G Via Wingle 46
13 Audio 47
13.1 AudioIN 47
13.2 AudioOUT(Talkback) 47
13.2.1 Options 47
13.2.2 SetupforVM22A 48
13.2.3 SetupforVM22E 50
13.2.4 TroubleshootingTalkback 50
13.3 UsingIPAudioDevices 52
14 Connecting PIR Detectors 53
14.1 RequiredPIRFirmware 53
14.2 ConnectingPIRDetectors 53
14.3 PIRAddressRange 53
14.4 DirectConnectiontotheMIOCard 53
14.5 ConnectionviatheUSB-to-RS-4858-ChannelDistributionUnit 55
14.6 ConnectionviatheUSB-to-Serial-PortRS-485Converter 57
14.7 ConnectionviatheIFM-485-STInterfaceModule 57
14.8 ConnectionviaIPModules(PROE-IPM) 58
14.8.1 Summary 58
14.8.2 SettinguptheIPModules 58
14.8.3 ConnectingtheIPModulestothePIRDetectors 63
15 Power Consumption 64
16 Retrieving the IP Address 65
17 Diagnostics 66
17.1 LogFilesandReports 66
17.2 RetrievingLogFiles 66
17.3 RetrievingReports 68
18 Web Pages 70
19 Maintenance 71
20 Full Reset by Flashing the DOM 72
20.1 FlashingtheImageFiletotheDOM 72
20.2 AfteraFullReset 74
21 Product Labelling 75
21.1 ProductNumberStructure 75
21.2 DeclarationofConformity 76
Appendix A – Abbreviations 77