ADT NVR4200 Series User Manual

Hybrid Standalone NVR User Guide 4 Web Service
Figure 4-22
4.7.2.4 3G
This feature is not supported by ADT.
4.7.2.5 PPPoE
To set up PPPoE:
1. Check the Enable box to enable the PPPoE feature.
2. Input the PPPoE User Name and Password you get from the Internet Service Provider.
3. Click Save.
4. Reboot the device.
The NVR connects to the internet via PPPoE after reboot. You can get the IP address from the WAN in
the IP address column.
Note: You must use the previous IP address in the LAN to login the device. Go to the IP address
item to see the current device information. You can access the client end via this new
address.
NVR4200 Series User Guide
148

ADT NVR4200 Series Specifications

General

Brand	ADT
Model	NVR4200 Series
Category	Network Hardware
Language	English