Hybrid Standalone NVR User Guide 4 Web Service
The following describes the Detect window:
Enable
Check the box to enable the motion detection function. Then select a channel to be enabled from the
dropdown list.
Period
This feature activates the Motion Detection function in the specified time periods.
To set the Motion Detect period:
1. Click the Setup button.
2. In the resulting setup dialog (see Figure 4-42), select a day of the week from the drop-down
menu.
3. For the selected day, check the box for one of the six 24-hour time periods and set the
corresponding recording range.
4. Repeat for other time periods if desired.
5. Click Save. The system reverts to the Motion Detect page.
Figure 4-42
Note:
• Set the Motion Detect record period.
• Navigate to Storage > Schedule to set the current channel as a scheduled recording.
Anti-dither
This feature sets a delay period before triggering the next Motion Detection event, to avoid re-
triggering on the same event. The delay period begins when the current motion detection event has
ended. The system only stores one event during the anti-dither period. The value ranges from 5s to
600s.
Sensitivity
There are six levels. The sixth level has the highest sensitivity.
NVR4200 Series User Guide
162
To Next Page
Loading...
Need help?
General