Hybrid Standalone NVR User Guide 4 Web Service
Figure 4-49
Tour
When an alarm occurs, this feature presents an alternating display (much like a slideshow) of the
channel(s) you set to record.
Check the box to enable, and the click the buttons for the channels that you want included in the
tour. The selected channels are highlighted.
Snapshot
When an alarm occurs, this feature takes a still image of the channel(s) you set to record.
Check the box to enable, and the click the buttons for the channels that you want included in the
snapshot. The selected channels are highlighted.
Checkboxes
Show Message. If enabled, a pop up alarm message appears in the local host screen.
Send Email. If enabled, an email alert is sent to you when an alarm occurs.
Alarm Upload. If enabled, the alarm signal is uploaded to the network.
Buzzer. If enabled, a buzzer sounds when an alarm occurs.
Message. If a 3G network is connected, a message is sent when a motion detection event
occurs. Note: This feature is not supported by ADT at this time.
NVR4200 Series User Guide
168
To Next Page
Loading...
Need help?
General