Hybrid Standalone NVR User Guide 4 Web Service
Figure 4-67
IP Conflict
To enable notification(s) when an IP conflict is detected:
1. Check the Enable box.
2. Check the box associated with the desired notifications:
Show Message. If enabled, a pop up alarm message appears in the local host screen.
Send Email. If enabled, an email alert is sent to you when an alarm occurs.
Buzzer. If enabled, a buzzer sounds when an alarm occurs.
Message. If a 3G network is connected, a message is sent when the anomalous event
occurs. Note: This feature is not supported by ADT at this time.
3. Click Save.
Figure 4-68
MAC Conflict
To enable notification(s) when a MAC conflict is detected:
1. Check the Enable box.
2. Check the box associated with the desired notifications:
Show Message. If enabled, a pop up alarm message appears in the local host screen.
Send Email. If enabled, an email alert is sent to you when an alarm occurs.
Buzzer. If enabled, a buzzer sounds when an alarm occurs.
Message. If a 3G network is connected, a message is sent when the anomalous event
occurs. Note: This feature is not supported by ADT at this time.
3. Click Save.
NVR4200 Series User Guide
185
To Next Page
Loading...