Hybrid Standalone NVR User Guide 4 Web Service
No Disk Space
To enable notification(s) when no disk space is detected:
1. Check the Enable box.
2. Enter the percentage of available disk space to be remaining for the alarm to be triggered.
3. Check the box associated with the desired notifications:
Show Message. If enabled, a pop up alarm message appears in the local host screen.
Send Email. If enabled, an email alert is sent to you when an alarm occurs.
Alarm Upload. If enabled, the alarm signal is uploaded to the network.
Buzzer. If enabled, a buzzer sounds when an alarm occurs.
Message. If a 3G network is connected, a message is sent when the anomalous event
occurs. Note: This feature is not supported by ADT at this time.
4. Click Save.
Figure 4-66
Network Disconnection
To enable notification(s) when the system becomes disconnected from the network:
1. Check the Enable box.
2. Check the box associated with the desired notifications:
Show Message. If enabled, a pop up alarm message appears in the local host screen.
Send Email. If enabled, an email alert is sent to you when an alarm occurs.
Buzzer. If enabled, a buzzer sounds when an alarm occurs.
Message. If a 3G network is connected, a message is sent when the anomalous event
occurs. Note: This feature is not supported by ADT at this time.
3. If desired, set up channels to record if this event occurs:
• Record Channel. The system automatically activates to record selected channels once
the error occurs. Check the box to enable, and the click the buttons for the channels that
you want recorded. The selected channels are highlighted.
• Delay. To avoid rerecording the same event, enter the number of seconds to wait after
the event has ended before a new recording can begin. This value ranges from 10s to
300s.
4. Click Save.
NVR4200 Series User Guide
184
To Next Page
Loading...
Need help?
General