AFL FlexScan FS200 OTDR - View and Edit User Fiber Type Settings

To View and Edit User Fiber Type Settings
• While in the SmartAuto Settings screen, make sure the User Fiber Type label is displayed in the Fiber Type eld.
• If not, touch the Fiber Type eld to display the Fiber Type menu and touch the User option to select.
• When back in the SmartAuto Settings screen, touch and hold the displayed User label to open the User Fiber Type settings screen and congure
settings as follows:
– Group Index of Refraction (GIR)
– Backscatter Coefcient (BC)
– Fiber Attenuation (A; Loss-per-Distance)
• Touch the desired parameter eld (e.g. GIR @1550 nm) to display its Editor screen.
– Edit the value using on-screen controls.
– Touch Done to save changes and return to the User Fiber Type settings screen.
– Touch Back to return to the SmartAuto Settings screen.
19
SmartAuto Settings Screen
User Fiber Type Settings Screen
User Settings Editor Screen
Touch and hold to open User
Fiber Type settings
Touch to select the User option
O verview
Settings
SmartAuto
Expert
Real-Time
OLS/OPM
Inspection
Results
Reports