Updating the configuration of a user
Only users who have a Windows administrator account can perform this task.
Use this procedure e.g. to change the Windows password of a user or to
replace a lost RFID key.
1. Go to the Windows Start menu > Agfa and click RFID Config Tool.
The RFID Configuration Tool dialog is displayed.
2. Select the user's RFID key from the list of configured RFID keys.
The configuration of the RFID key is displayed.
3. Click Edit.
4. Apply the updates to the configuration.
• If the user's RFID key was lost, put a new RFID key on the RFID reader
to fill in the serial number.
The old RFID key cannot be used to start the system anymore.
• If the password of a user has been changed on Windows, enter the new
password.
Even if the password has not changed, the password must be entered
before saving the configuration!
If multiple RFID keys are linked to this Windows user account, the
procedure must be repeated for each RFID key.
5. Click Save.
6. Click Send to Device.
The card can be used for starting the DR 100s.
7. Close the RFID Configuration Tool.
142 | DR 100s | Advanced Operation
0411D EN 20220627 1040
To Next Page
Loading...
