Problem with RFID reader while starting or stopping
DR 100s
Details The procedure to start or to stop DR 100s does not succeed.
The power status indicator light is off or blinking.
First problem
situation
The power status indicator light is not starting to blink
when an RFID key is put on the RFID reader.
Solution Press and hold the power off button for 3 seconds.
Try reading an RFID key.
Second prob-
lem situation
The power status indicator light keeps blinking while
there’s no RFID key on the RFID reader.
First solution Check if there’s an RFID key laying close by the RFID read-
er. Remove the RFID key. The indicator light stops blinking.
Second solu-
tion
Press and hold the power off button for 10 seconds.
Try reading an RFID key.
DR 100s | Problem solving | 151
0411D EN 20220627 1040
To Next Page
Loading...
