AGFA DR 100s - DR Detector Labeling

Labeling the DR Detectors
CAUTION:
Selecting the wrong DR detector can cause the need to retake
the image.
On a configuration with multiple wireless DR Detectors of the same type, it is
required to apply labeling to the DR Detector containing a unique nickname
for each DR Detector. The nicknames must be configured on the NX
workstation. The DR Detector Switch shows which DR Detector is active and
shows its status, by means of the nickname of the DR Detector.
DR 100s | Introduction | 59
0411D EN 20220627 1040