1290 Infinity Quaternary Pump User Manual 283
LAN Configuration
13
Manual Configuration
3 Type
? and press enter to see the available commands.
Figure 53 Telnet Commands
4 To change a parameter follows the style:
• parameter value, for example:
ip 134.40.27.230
Then press [Enter], where parameter refers to the configuration
parameter you are defining, and value refers to the definitions you are
assigning to that parameter. Each parameter entry is followed by a
carriage return.
Tabl e 19 Telnet Commands
Value Description
? displays syntax and descriptions of commands
/ displays current LAN settings
ip <x.x.x.x> sets new ip address
sm <x.x.x.x> sets new subnet mask
gw <x.x.x.x> sets new default gateway
exit exits shell and saves all changes
To Next Page
Loading...
