231
Analytical Sequences
Sequence control
Aborting a sequence
When a sequence is aborted, it stops immediately without waiting for the current
run to finish. These will cause a sequence to abort:
You can correct the problem and then resume the sequence. The aborted sample
run will be repeated.
A run is stopped by
pressing the [Stop] key.
A sampler error occurs
producing an error message.
The GC detects a configuration
mismatch during a method load
(see chapter 8, "Analytical
Methods").
A running sequence tries to
load an empty method.
The sampler is turned off.
To Next Page
Loading...
Need help?
General
