Agilent Technologies 8712ET Programmer's Guide

11-32 Programmer’s Guide
SCPI Command Summary
SCPI Device Command Summary
Table 11-14 MMEMory (2 of 3)
1. File names may include the mass storage device name—MEM: (internal non-volatile
memory), RAM:(internal volatile memory), INT: (internal 3.5” disk drive), or NFS
local path. Wildcards ? and * may be used.
2. Be sure to catalog the desired disk using MMEM:MSIS before using this command.
3. Binary parameters accept the values of 1 (on) and 0 (off) in addition to ON and OFF.
SUBSYSTEM COMMANDS FORM DESCRIPTION
MMEMory:MOVE
<string1>,<string2>
1, 2
command
only
Moves or renames a file —
string1 is the source (or old)
filename and string2 is the
destination (or new) filename.
MMEMory:MSIS <string> STRING Selects a mass storage device —
choose MEM: (internal memory),
INT: (internal floppy disk drive),
etc.
MMEMory:RDIRectory <string>
2
command
only
Deletes a directory from a DOS
formatted disk.
MMEMory:STORe:STATe 1,
<string>
1, 2, 3
command
only
Saves an instrument state to
mass storage — string is the
filename.
MMEMory:STORe:STATe:CORRection
<ON|OFF>
3
NR1 Turns the calibration on/off —
part of the definition of a saved
file.
MMEMory:STORe:STATe:FORMat
<char>
CHAR Saves instrument state files to
be compatible with older "A/B"
model analyzers (choose B8711),
or with current "C" model
analyzers (choose C8711).
MMEMory:STORe:STATe:ISTate
<ON|OFF>
3
NR1 Turns the instrument state
on/off — part of the definition of
a saved file.
MMEMory:STORe:STATe:TRACe
<ON|OFF>
3
NR1 Turns the data trace on/off —
part of the definition of a saved
file.

Agilent Technologies 8712ET Specifications

General

Brand	Agilent Technologies
Model	8712ET
Category	Measuring Instruments
Language	English