Agilent Technologies 8712ET Programmer's Guide

11-46 Programmer’s Guide
SCPI Command Summary
SCPI Device Command Summary
Table 11-19 SENSe (9 of 16)
1. Binary parameters accept the values of 1 (on) and 0 (off) in addition to ON and OFF.
2. For use with fault location measurements on analyzers with Option 100 only.
3. Numeric parameters may include an appropriate suffix; if no suffix is included, the
default (HZ for frequency or S for time) is assumed.
SUBSYSTEM COMMANDS FORM DESCRIPTION
SENSe[1|2]:CORRection:MODel
:CONNector[:IMMediate]
command
only
Measures the cable connector and
determine the optimum values for
connector length and connector
capacitance.
3
SENSe[1|2]:CORRection:OFFSet
:PHASe
NR3 Specifies the phase offset.
SENSe[1|2]:CORRection:ONEPort
:REFLection[:IMMediate]
command
only
Retrieves the user one-port
reflection error correction factors
from internal memory and applies
them to the current measurement.
SENSe[1|2]:CORRection:ONEPort
:TRANSmission[:IMMediate]
command
only
Retrieves the user one-port
transmission error correction
factors from internal memory and
applies them to the current
measurement.
SENSe[1|2]:CORRection:TWOPort
[:IMMediate]
command
only
Retrieves the user two-port error
correction factors from internal
memory and applies them to the
current measurement.
SENSe[1|2]:CORRection:PEAK
:COAX[:STATe]<ON|OFF>
1
NR1 Turns multi-peak correction on or
off.
2
SENSe:CORRection:RVELocity
:COAX <num>
3
NR3 Specifies the velocity factor to be
used when displaying the distance
for electrical length and port
extensions. 1.0 the speed of light.
SENSe[1|2]:CORRection:RVELocity
[:IMMediate]
command
only
Measures the cable and determine
the optimum values for cable loss
and velocity factor.
2

Agilent Technologies 8712ET Specifications

General

Brand	Agilent Technologies
Model	8712ET
Category	Measuring Instruments
Language	English