11-48 Programmer’s Guide
SCPI Command Summary
SCPI Device Command Summary
Table 11-19 SENSe (11 of 16)
1. Numeric parameters may include an appropriate suffix; if no suffix is included, the
default (HZ for frequency or S for time) is assumed.
2. For use with fault location measurements on analyzers with Option 100 only.
SUBSYSTEM COMMANDS FORM DESCRIPTION
SENSe[1|2]:FREQuency:MODE <char> CHAR Sets the fault location
measurement to CENTer
(bandpass) or LOWPass.
2
SENSe[1|2]:FREQuency:SPAN <num>
1
NR3 Sets the frequency span of the
RF source.
SENSe[1|2]:FREQuency:SPAN
:MAXimum <num>
1
NR3 Sets the maximum frequency
span of the RF source for
bandpass fault location
measurements.
2
SENSe[1|2]:FREQuency:STARt <num>
1
NR3 Sets the start frequency of the
RF source.
SENSe[1|2]:FREQuency:STOP <num>
1
NR3 Sets the stop frequency of the
RF source.
SENSe[1|2]:FREQuency:ZSTOp
<num>
1
NR3 Sets the Z cutoff frequency for
cable impedance calculations.
2
SENSe[1|2]:FUNCtion? query only
STRING
See SENSe[1|2]:FUNction
‘. . . . .’ commands for
string definitions.
Queries the measurement
function — returns a string
that defines the current
measurement function.
To Next Page
Loading...
Need help?
General
