Agilent Technologies 8712ET - Page 253

Programmer’s Guide 11-55
SCPI Command Summary
SCPI Device Command Summary
Table 11-21 STATus (1 of 4)
1. Returns the sum of the decimal weights (2
n
where n is the bit number) of all bits
currently set. For more information on using the status registers, refer to Chapter
5, “Using Status Registers.”
2. <num> is the sum of the decimal weights of all bits to be set.
SUBSYSTEM COMMANDS FORM
DESCRIPTION
STATus:DEVice:CONDition? query only
NR1
Reads the Device Status
condition register.
1
STATus:DEVice:ENABle <num> NR1 Sets and queries bits in the
Device Status enable register.
2
STATus:DEVice[:EVENt]? query only
NR1
Reads and clears the Device
Status event register.
1
STATus:DEVice:NTRansition <num> NR1 Sets and queries bits in the
Device Status negative
transition register.
2
STATus:DEVice:PTRansition <num> NR1 Sets and queries bits in the
Device Status positive
transition register.
2
STATus:OPERation:AVERaging
:CONDition?
query only
NR1
Reads the Averaging status
condition register.
1
STATus:OPERation:AVERaging:
ENABle <num>
NR1 Sets and queries bits in the
Averaging status enable
register.
2
STATus:OPERation:AVERaging
[:EVENt]?
query only
NR1
Reads and clears the Averaging
status event register.
1
STATus:OPERation:AVERaging
:NTRansition <num>
NR1 Sets and queries bits in the
Averaging status negative
transition register.
2