Agilent Technologies 8712ET - Page 254

11-56 Programmer’s Guide
SCPI Command Summary
SCPI Device Command Summary
Table 11-21 STATus (2 of 4)
1. <num> is the sum of the decimal weights of all bits to be set.
2. Returns the sum of the decimal weights (2
n
where n is the bit number) of all bits
currently set. For more information on using the status registers refer to Chapter
5, “Using Status Registers.”
SUBSYSTEM COMMANDS FORM
DESCRIPTION
STATus:OPERation:AVERaging
:PTRansition <num>
NR1 Sets and queries bits in the
Averaging status positive transition
register.
1
STATus:OPERation:CONDition? query only
NR1
Reads the Operational status
condition register.
2
STATus:OPERation:ENABle
<num>
NR1 Sets and queries bits in the
Operational status enable register.
1
STATus:OPERation[:EVENt]? query only
NR1
Reads and clears the Operational
status event register.
2
STATus:OPERation:MEASuring
:CONDition?
query only
NR1
Reads the Measuring status
condition register.
2
STATus:OPERation:MEASuring
:ENABle <num>
NR1 Sets and queries bits in the
Measuring status enable register.
1
STATus:OPERation:MEASuring
[:EVENt]?
query only
NR1
Reads and clears the Measuring
status event register.
2
STATus:OPERation:MEASuring
:NTRansition <num>
NR1 Sets and queries bits in the
Measuring status negative
transition register.
1
STATus:OPERation:MEASuring
:PTRansition <num>
NR1 Sets and queries bits in the
Measuring status positive
transition register.
1