Agilent Technologies 8712ET - Page 255

Programmer’s Guide 11-57
SCPI Command Summary
SCPI Device Command Summary
Table 11-21 STATus (3 of 4)
1. <num> is the sum of the decimal weights of all bits to be set.
2. Returns the sum of the decimal weights (2
n
where n is the bit number) of all bits
currently set. For more information on using the status registers refer to Chapter 5,
“Using Status Registers.”
SUBSYSTEM COMMANDS FORM
DESCRIPTION
STATus:OPERation:NTRansition
<num>
NR1 Sets and queries bits in the
Operational Status negative
transition register.
1
STATus:OPERation:PTRansition
<num>
NR1 Sets and queries bits in the
Operational Status positive
transition register.
1
STATus:PRESet command
only
Sets bits in most enable and
transition registers to their
default state.
STATus:QUEStionable:CONDition? query only
NR1
Reads the Questionable Status
condition register.
2
STATus:QUEStionable:ENABle <num> NR1 Sets and queries bits in the
Questionable Status enable
register.
1
STATus:QUEStionable[:EVENt]? query only
NR1
Reads and clears the
Questionable Status event
register.
2
STATus:QUEStionable:LIMit
:CONDition?
query only
NR1
Reads the Limit Fail condition
register.
2