Agilent Technologies 8712ET - Page 256

11-58 Programmer’s Guide
SCPI Command Summary
SCPI Device Command Summary
Table 11-21 STATus (4 of 4)
1. <num> is the sum of the decimal weights of all bits to be set.
2. Returns the sum of the decimal weights (2
n
where n is the bit number) of all bits
currently set. For more information on using the status registers refer to Chapter 5,
“Using Status Registers.”
SUBSYSTEM COMMANDS FORM
DESCRIPTION
STATus:QUEStionable:LIMit:
ENABle <num>
NR1 Sets and queries bits in the Limit
Fail enable register.
1
STATus:QUEStionable:LIMit
[:EVENt]?
query only
NR1
Reads and clears the Limit Fail
event register.
2
STATus:QUEStionable:LIMit
:NTRansition <num>
NR1 Sets and queries bits in the Limit
Fail negative transition register.
1
STATus:QUEStionable:LIMit
:PTRansition <num>
NR1 Sets and queries bits in the Limit
Fail positive transition register.
1
STATus:QUEStionable:NTRansition
<num>
NR1 Sets and queries bits in the
Questionable Status negative
transition register.
1
STATus:QUEStionable:PTRansition
<num>
NR1 Sets and queries bits in the
Questionable Status positive
transition register.
1