Programmer’s Guide 11-65
SCPI Command Summary
SCPI Device Command Summary
Table 11-23 SYSTem (7 of 8)
1. Refer to "Automated Measurement Setup and Control" in Chapter 7 of the User's
Guide for more information on using this command.
SUBSYSTEM COMMANDS FORM
DESCRIPTION
SYSTem:PRESet command
only
Performs a system preset —
this is the same as the front
panel key.
SYSTem:SET <block> command
only
Sends a learn string (obtained
using *LRN?) to the analyzer
— this command is included in
the learn string.
SYSTem:SET:LRN? [<USER>]
1
BLOCK Queries or set the instrument
state.
SYSTem:SET:LRNLong? [<USER>]
1
BLOCK Queries or set the instrument
state, data, and calibration.
Similar to save/recall.
SYSTem:TIME <num1>,<num2>,<num3> NR1, NR1,
NR1
Sets the hour (num1), minute
(num2) and second (num3) of
the real time clock.
SYSTem:VERSion? query only
NR2
Queries the SCPI version of
the analyzer. See *IDN? to
query the firmware revision.
PRESET
To Next Page
Loading...
