1-96 Chapter1
Alphabetical Command Reference
FWD
FWD
Syntax
FWD<I|M|T>;
Description
These commands are OPC-compatible if there is only one standard in the class. If there is
just one standard, that standard is measured automatically. If there is more than one
standard in the class, the standard being used must be selected with the STAN command.
Front Panel Equivalents
Command Description Range Query Response
FWDI Selects the forward isolation calibration
class during a 2-port calibration sequence.
N/A N/A
FWDM Selects the forward match calibration
class during a 2-port calibration sequence.
N/A N/A
FWDT Selects the forward transmission
calibration class during a 2-port
calibration sequence.
N/A N/A
Command Hardkey Softkey
FWDI
FWDM
FWDT
Cal
Cal
Cal
To Next Page
Loading...
Need help?
General
