1-178 Chapter1
Alphabetical Command Reference
POWL
POWL
Syntax
POWL<FREQ|LOSS><num>; or POWL<FREQ|LOSS>?;
POWLLIST;
Description
Front Panel Equivalents
Command Description Range Query Response
POWLFREQ Selects the frequency for which a power
loss correction is entered. This must be
followed by a POWLLOSS<num>; command,
which sets the value.
stimulus range
1
1. For frequency or power sweeps, refer to “Preset State and Memory Allocation,” in your analyzer’s reference
guide. For CW time: 0 to 24 hours. For frequency sweep, transform on: ± 1/frequency step. For CW time sweep,
transform on: ±1/time step.
<num><
L
F
>
POWLLIST Beginsediting a power loss list for a power
meter calibration.
N/A N/A
POWLLOSS Sets the loss value for a particular
frequency, set by POWLFREQ, in the power
loss list.
−9900 to 9900 dB
<num><
L
F
>
Command Hardkey Softkey
POWLFREQ
POWLLIST
POWLLOSS
Cal
Cal
Cal
To Next Page
Loading...
