1-212 Chapter1
Alphabetical Command Reference
RST
RST
Syntax
RST;
Description
Front Panel Equivalents
NOTE Pressing the key on the analyzer will either invoke the factory preset
state, or a user-selected state (if one has been set up). Sending the RST
command will always invoke the factory preset state. This is true even if the
analyzer is currently set up to recall a user preset state when the
key is pressed. For more information on user presets, see your analyzer’s
user’s guide.
Command Description Range Query Response
RST Presets the analyzer to the factory preset
state. OPC-compatible. See Appendix A ,
“Preset Conditions.”
N/A N/A
Command Hardkey Softkey
RST N/A
Preset
Preset
Preset
To Next Page
Loading...
Need help?
General
