Chapter 1 1-107
Alphabetical Command Reference
INPU
INPURAW3 Inputs raw data array 3 (S
12
data). After the data is
received, the analyzer stops sweeping, error-corrects
the data, then formats and displays the data.
N/A N/A
INPURAW4 Inputs raw data array 4 (S
22
data). After the data is
received, the analyzer stops sweeping, error-corrects
the data, then formats and displays the data.
N/A N/A
1. These commands input an individual error coefficient array. Before sending an array, issue a CALIXXXX;
command, where XXXX specifies the calibration type. (See “CALI” earlier in this book.) Then input the array or
arrays. Lastly store the data with the SAVC command. The instrument goes into hold, displaying uncorrected
data. Complete the process by triggering a sweep, with the CONT command (for continuous sweep) or the SING
command (for a single sweep). See Table 1-4 for the contents of the different arrays.
2. Does not require a preceding “FORM” command.
Command Description Range Query
Response
To Next Page
Loading...
Need help?
General
