6-10 Chapter6
Error Reporting
Error Messages in Numerical Order
32 WRITE ATTEMPTED WITHOUT SELECTING INPUT TYPE
33 SYNTAX ERROR
34 BLOCK INPUT ERROR
35 BLOCK INPUT LENGTH ERROR
36 SYST CTRL OR PASS CTRL IN LOCAL MENU
37 ANOTHER SYSTEM CONTROLLER ON GPIB
38 DISK: not on, not connected, wrong address
39 DISK HARDWARE PROBLEM
40 DISK MEDIUM NOT INITIALIZED
41 NO DISK MEDIUM IN DRIVE
42 FIRST CHARACTER MUST BE A LETTER
43 ONLY LETTERS AND NUMBERS ARE ALLOWED
44 NOT ENOUGH SPACE ON DISK FOR STORE
45 NO FILE(S) FOUND ON DISK
46 ILLEGAL UNIT OR VOLUME NUMBER
47 INITIALIZATION FAILED
48 DISK IS WRITE PROTECTED
49 DISK WEAR-REPLACE DISK SOON
50 TOO MANY SEGMENTS OR POINTS
51 INSUFFICIENT MEMORY
54 NO VALID MEMORY TRACE
55 NO VALID STATE IN REGISTER
56 INSTRUMENT STATE MEMORY CLEARED
57 OVERLOAD ON INPUT R, POWER REDUCED
58 OVERLOAD ON INPUT A, POWER REDUCED (ES)
OVERLOAD ON REFL PORT, POWER REDUCED (ET)
59 OVERLOAD ON INPUT B, POWER REDUCED (ES)
OVERLOAD ON TRANS PORT, POWER REDUCED (ET)
61 SOURCE PARAMETERS CHANGED
62 NOT VALID FOR PRESENT TEST SET
63 CALIBRATION REQUIRED
64 CURRENT PARAMETER NOT IN CAL SET
Error
Number
Error
To Next Page
Loading...
Need help?
General
