8-14
Instrument BASIC
Loading, Storing, and Running
Figure 8-4 Test Procedure and Test Library Files
3 Select the Procedure field shown by item (3), see Figure 8-5 on page 8-15.
4 Enter the Test Procedure filename that you want to make or delete by using the
alpha/numeric list of characters shown by item (4), see Figure 8-5 on page 8-15.
5 Select the Location to Make or Delete field shown by item (5),
see Figure 8-5 on page 8-15, then select the file’s location to be on memory card,
RAM, or Disk from the list of choices shown in item (4).
6 Enter up to two lines of comments to identify the new Test Procedure. Refer to
item (6), see Figure 8-5 on page 8-15.
7 Select whether the new Test Procedure will use the current Test Library or if it
will use no library as shown by item (7), see Figure 8-5 on page 8-15.
8 Select where the program for the Test Procedure is to be found. Refer to item (8),
see Figure 8-5 on page 8-15.
9 Select the Make Procedure field or the Delete Procedure field as
shown in item (9).
Use the Pass Number field in the lower-right corner of the Procedure Manager
menu to unsecure a Test Procedure file. The ROM program SECURE_IT is used to
secure Test Procedure files.
2
1
To Next Page
Loading...
Need help?
General
