Chapter 10 341
CDMA Digital Modulation
IS-95A Modulation
Configuring the RF Output
1. Set the RF output frequency to 890.01 MHz.
2. Set the output amplitude to −10 dBm.
3. Press
RF On/Off.
The user-defined multicarrier CDMA signal is now available at the RF OUTPUT connector.
Applying Changes to an Active Multicarrier CDMA State
If the CDMA format is currently in use (CDMA Off On set to On) while changes are made in the
Multicarrier CDMA Setup table editor, you must apply the changes before the updated waveform will
be generated.
From the Multicarrier CDMA Setup table editor, press the following keys to apply the changes and
generate a new user-defined multicarrier CDMA waveform based on the updated values:
Return > Apply Multicarrier.
To store a custom multicarrier CDMA state file, refer to, “Storing a Component Test Waveform to Memory”
on page 316.
To recall a custom multicarrier CDMA state file, refer to “Recalling a Component Test Waveform” on
page 317.
To Next Page
Loading...
Need help?
General
