Appendix A: Integrating the PlateLoc into third-party systems
PlateLoc User Guide
114
CycleComplete Description
This event occurs when the PlateLoc successfully completes a non-
blocking seal cycle.
Parameters
Returns
None
GetCycleCountCom
plete
Description
This event occurs when the PlateLoc successfully retrieves the odometer
value. The odometer value is returned in the cycle-count parameter in
the non-blocking mode.
Parameters
Returns
None
Error Description
This event occurs when an error occurs during any non-blocking
method.
Parameters
Name Type
reserved LONG
Name Type
cycle_count LONG
Name Type Range Description
number SHORT not used
description BSTR* a description of the error
scode LONG not used
source BSTR not used
helpfile BSTR not used
HelpContext LONG not used
CancelDisplay VARIANT_BOOL* set to TRUE to disable the
stock event handler
behavior, which is to
display a dialog box with
the description in it.
To Next Page
Loading...
Need help?
General
