Agilent Technologies PlateLoc User Manual

51
Chapter 3: Getting started
PlateLoc User Guide
Adjusting the touch screen contrast
About this topic This topic explains how to adjust the touch screen contrast.
Before you start Make sure the PlateLoc is turned on.
Adjusting the touch
screen contrast
To adjust the touch screen contrast:
1. From the touch screen
Main Menu, press Setup.
2. In the Set Parameters Menu that appears, press the up or down arrow
on either side of the contrast symbol ( ) to increase or decrease
contrast.
3. Press Done to save the new contrast setting and return to the Main
Menu.
00206
PlateLoc
screen menu 1
Main Menu
Seal Time: 1.8s
Set Time: 1.8 Seconds
Set Temp: 20 Degrees C
Air pressure: 89 psi
Seal Temp: 20°C
Status: Ready
Setup
R
U
N
Press Setup.
Press arrows to
adjust contrast.
00207
PlateLoc
screen menu 2
00207
PlateLoc
screen menu 2
Set Parameters Menu
Set Seal Time: 1.8s
Version 3.7.2 Cycle count: 63779
Set Seal Temp: 20°C
Service Done

Agilent Technologies PlateLoc Specifications

General

Brand	Agilent Technologies
Model	PlateLoc
Category	Laboratory Equipment
Language	English