Agilent Technologies PlateLoc User Manual

Chapter 4: Sealing plates
PlateLoc User Guide
74
Stopping a seal cycle in progress
About this topic This topic explains how to stop the PlateLoc when a seal cycle is in
progress. You can use this method to stop the device in an emergency.
Standalone device
procedure
To stop a seal cycle that is in progress:
1. On the
Main Menu, press STOP.
To stop a seal cycle in an emergency:
1. In case the STOP button on the touch screen does not work or is not
responding fast enough, turn off the PlateLoc. The on/off switch is
on the back of the device. Alternatively, you can disconnect the
power to the PlateLoc.
The following diagram shows the location of the on/off switch and
the power connection on the back of the PlateLoc.
Lab automation
system procedure
You can stop a seal cycle from the Velocity11 lab automation system
software. For detailed instructions, see the Velocity11 lab automation
system software user guide.
00206
PlateLoc
screen menu 1
Main Menu
Seal Time: 1.8s
Set Time: 1.8 Seconds
Set Temp: 160 Degrees C
Air pressure: 89 psi
Seal Temp: 160°C
Status: Running
Setup
S
T
O
P
Press to stop the seal
cycle in progress.
00191
PlateLoc
connections
00191
PlateLoc
connections
Press to turn off.
Disconnect power.

Agilent Technologies PlateLoc Specifications

General

Brand	Agilent Technologies
Model	PlateLoc
Category	Laboratory Equipment
Language	English