v
Preface
PlateLoc User Guide
What this guide covers
What is covered This guide covers the installation, setup, and operation of the PlateLoc
that is used in the following ways:
❑ As a single device, controlled from the built-in touch screen
interface
❑ Integrated with other devices in a Velocity11 lab automation system,
controlled from a computer
This guide also provides the ActiveX reference information needed to
integrate the PlateLoc in a third-party lab automation system.
What is not covered This guide does not provide instructions for:
❑ Creating protocols and setting task parameters in the Velocity11 lab
automation software
❑ Operating other devices in Velocity11 lab automation systems
❑ Operating the PlateLoc integrated into a third-party lab automation
system
Firmware version This guide documents PlateLoc firmware version 3.7.2.
Software version This guide documents PlateLoc ActiveX (PlateLoc.ocx) version 7.
Related guides The PlateLoc User Guide should be used in conjunction with the
following user documents:
❑ Velocity11 lab automation system user guides, such as the BenchCel
User Guide and the BioCel User Guide. These user guides provide the
system setup requirements and user operation instructions.
❑ Velocity11 lab automation system software user guides, such as the
VWorks User Guide. These user guides explain how to create
protocols and set task parameters for each device in the system.
❑ Third-party lab automation system user documents. These
documents explain how to set up and use the third-party lab
automation system.
To Next Page
Loading...
Need help?
General
