Chapter 1: PlateLoc introduction
PlateLoc User Guide
18
Safety information
About this topic This topic provides information for the safe operation of the PlateLoc.
Before using the
PlateLoc
Before using the PlateLoc, your organization should make sure that you
are properly trained in:
❑ General laboratory safety
❑ The correct and safe operation of the PlateLoc
❑ The correct and safe operation of lab automation systems or
components used in combination with the PlateLoc
If you are the person in your organization responsible for training others
on the PlateLoc and you have a safety question, contact Velocity11
Technical Support.
Safety standards The PlateLoc is CE certified and complies with the following CE safety
directive: EN 61010-1:1993, safety requirements for electrical equipment
for measurement, control, and laboratory use, including amendments 1
and 2.
The PlateLoc is designed to meet UL specifications.
For the latest compliance information, contact Velocity11 Technical
Support.
Safety labels Pay attention to safety labels on the PlateLoc. A safety label consists of a
warning symbol, a description of the warning, and information that
helps you to avoid the safety hazard.
The following diagram shows the safety label that is placed on the front
of the PlateLoc to warn you of high-temperature hazards.
00196
PlateLoc
Front
To Next Page
Loading...
Need help?
General
