Chapter 3: Getting started
PlateLoc User Guide
42
Turning on and turning off the power
About this topic This topic explains how to turn on and turn off the power to the
PlateLoc.
Before turning on
the PlateLoc
Make sure:
❑ The lab requirements are met.
❑ You have properly installed the PlateLoc.
❑ You are trained in the proper operation of the PlateLoc.
Turning on the
PlateLoc
To turn on the PlateLoc:
1. Press the on/off switch on the back of the PlateLoc to the on
position (I).
The following diagram shows the location of the on/off switch on
the back of the PlateLoc. The on/off switch in the diagram is in the
on position.
When you turn on the PlateLoc, the touch screen displays the
Insufficient Air Pressure error message. This is because you have not yet
turned on the air to the PlateLoc. Proceed to “Turning on and turning off
the air” on page 44 to turn on the air.
00191
PlateLoc
connections
00191
PlateLoc
connections
Press to turn on.
To Next Page
Loading...
Need help?
General
