154
Settings and Adjustments
Configure on the device.
4
– The Set Destination Relay screen is displayed.
(4) Tap [NEW] to configure the terminal for which to control the output terminal.
*To change an output terminal control station that has already been registered, tap the station to change,
and then tap [EDIT].
*To delete an output terminal control station that has already been registered, tap the station to delete, and
then tap [DELETE].
– The Set Destination screen is displayed.
(5) Tap the station for which to control the output terminal.
*Refer to “Searching and Specifying (→page 31)” to search stations.
(6) Tap [ENTER].
– The Set Destination Relay screen is displayed.
To Next Page
Loading...
