203
Settings and Adjustments
Configuring the device on a PC
4
■ Transfer Destination List
■ Re-Transfer Destination
Delay Transfer
An incoming call can be automatically transferred if it is received during delay transfer and not answered over a
certain period of time (delay time).
Entry Description Settings Default values
Station Number Configure the station number of the transfer
destination station for absent transfer. Up to 10
transfer destination stations can be set.
However, if the calling station is IX-MV, IX-DA(-
*), or IX-BA, calls will only be transferred to the
station set as number 1 in the series. IXW-MA
cannot be configured as a transfer destination.
3-32 digits -
Important
• Do not configure multiple VoIP phones as transfer destinations. If multiple VoIP phones are configured, calls will be transferred
to only one VoIP phone.
Entry Description Settings Default values
Re-Transfer Destination Configure the station number of the transfer
destination station for absent transfer for a
transferred call. Only a single station can be set
as the transfer destination. However, if the
calling station is IX-MV, IX-DA(-*), or IX-BA, the
call will not be re-transfered, but will be received
by this station. IXW-MA cannot be configured as
a transfer destination.
3-32 digits -
Important
• When an incoming call is received from a VoIP Phone, the call will be received without transferring even when transfer is set.
To transfer the call, configure transferring on the IP-PBX.
To Next Page
Loading...
Need help?
General
