Chapter 6: Creating and Editing Sounds
Page 93
Editing a Sound
This allows you to edit a sound loaded from a disk or sampled into the memory.
Hold down SHIFT and press TRIM (or 5 on the numeric pad), the TRIM mode screen appears.
.........................................................
PLAY XPLAY XEDITTRIM
St: 105 End: 85242 View:LEFT
ZONELOOP PARAMS
Snd:loop_1 (ST) PLAY X:ALLPLAY X:ALL
Sound display and order can be changed while in the TRIM, LOOP or ZONE screens, by press-
ing the TRIM, LOOP or ZONE key again (example: F2 in the LOOP page) The display can be
toggled between Memory (order recorded in memory), Size (order of file size), Name (alphabetical
order).
Selecting a Sound
Move the cursor to the Snd: field and select the sound by rotating the DATA wheel. With stereo
samples, (ST) will appear after the sample name.
Renaming or Displaying the Specification of the Sound
To open the Sound window, select the Snd: field and press OPEN WINDOW.
........................
......................................................................................................
........................................................................................................
............................
CLOSE COPYDELETE CONVRT
Sound
Sound name:Sound name:loop_1
<Sound spec.><Sound spec.> Rate: 44100HzRate: 44100Hz
Type:MONO Size:862kbytes
.....................................................................................................
•
Sound name:
This changes the name of the sound.
Tap a drum pad or rotate the DATA wheel to display the name window.
Enter a name and press the ENTER key to confirm.
Note: If you do not press ENTER and move to another page, the name will not be
saved.
To Next Page
Loading...
Need help?
General
