Chapter 10: Disk Operation
Page 153
This icon is also displayed:
MPC2000XL
Before Proceeding to Use a Floppy Disk
Do NOT press the disk eject button when you are using a floppy disk and the light of the disk drive
on the front panel of the MPC2000XL is on. The data or disk may be damaged or destroyed.
SETTING UP the Primary Device
This sets up the primary device the MPC2000XL searches the file to load automatically when it is
turned on. You can also select the type of file to be loaded.
1
Hold down SHIFT and press LOAD (3 on the numeric kaypad) followed by SETUP [F4].
The following SETUP screen will appear.
FORMATSAVE SETUPLOAD
Primary device:Primary device:FLOPPY
Auto loding file type:APS+ALLAuto loding file type:APS+ALL
2
Select the primary device in the Primary device:field.
This selects the device that becomes active when the MPC2000XL is turned on. The
avaiable options are, FLOPPY, SCSI-O ~ SCSI-7, and F-ROM.
3
Move the cursor to the Auto loading file type: field and select the type of
file you want to load.
This selects the type of file that is automatically loaded from the device selected above
when the MPC2000XL is turned on.
The available options are, APS+ALL, ALL, APS, and OFF (refer to the subsequent
explanation of file types). The MPC2000XL will load the first APS and/or ALL file found
automatically.
To Next Page
Loading...
Need help?
General
